EON TIMER LAG HOW TO
EON TIMER LAG INSTALL
EON TIMER LAG ZIP FILE

Search for drivers wherever you installed the Intel software. If not, double click on whatever the USB Blaster shows, or the “unknown device” if nothing automatically installed:Ĭlick on “Update Driver”, then “Browse my computer for driver software”: You’ll want to check your Device Manager to make sure the USB Blaster was detected as an “Altera USB Blaster”. – Connect your USB Blaster and check that it installed correctly. Even on my fast PC, it took about ten minutes. This might take a really long time, as I believe it’s downloading more components during the installation.

EON TIMER LAG INSTALL

With these, there’s no need to install the whole Quartus Prime suite or to register: Here’s direct links to the programmer only. Luckily, the programmers are really cheap, the software is free and the instructions below (click on all pics for full-sized) should give you all the info you need to flash your own. The only downside of the TS is you need to use a “USB Blaster” and special software to flash firmware, you can’t just plug it into your computer. Lastly, extract the file inside that zip, which will be labeled “lagtester.pof” – This is the file containing the firmware and setup.

EON TIMER LAG ZIP FILE

Once it’s done, click on the zip file and download it to your computer. Please be patient, as this can take up to a few minutes. To assign these resolutions to each slot on the Time Sleuth, head to the main website and create your configuration: Īfter you’ve chosen a resolution for each position, hit “Generate Firmware” and wait for the file to be created. The Time Sleuth lag testing device can be programmed with up to five different resolutions and at the moment, there are 17 to choose from, including 50 and 60Hz modes.

EON TIMER LAG HOW TO

While this video isn’t directly about the TS, it’s a perfect representation of how it works, as well as how to use it with CRT’s and through analog converters: MAKE SURE TO SET YOUR TV TO GAME MODE FOR THE BEST RESULTS!!! In fact, I suggest you toggle game mode, just to get a sense of how much lag is being saved. Lastly, hold the TS’s sensor up to the white bars that are generated and it will display exactly how much time it takes from when the signal is sent, to when the TS’s sensor detects it on the screen. Next, set the desired resolution via the selector knob and hold the time sleuth up to your TV. If your TV doesn’t have a USB port any charger should work fine, including a small battery charger. Then connect a USB cable to your TV’s USB port for power. To use the TS, simply connect an HDMI cable between it and your TV. It was created by Christof and Dan, the makers of amazing HDMI mods for consoles such as the Dreamcast and PlayStation 1. Then, you hold the sensor that’s on the back of the TS up to those white bars and the device will display the amount of time it takes from when the signal is sent, to when the signal is detected. The Time Sleuth is a device that sends an HDMI signal that flashes white bars on your display.

Eon timer lag